| |

Welcome to Coleman Air, Inc.

Enter the search term for the product you are looking for below:

More Options
Display my previous orders

To repeat a previous order in part or full, click the link above. To purchase or view any of the items you have purchased before, simply select it from the list below.
..Blocking Diodes
Solar/Wind/Hydro...
Fasteners...
..Rectifiers
Rectifiers and Diodes...
Components (Electronic)...
Breakers, Switches and More...
Solar Connectors...
Bolts...
Nuts...
Screws...
Washers...
Diodes...
Articles and Info
Miscellaneous
440 Amp 12/24/48 V Wind/Solar Battery Charge Controller
160A Amp Wind/Solar Diversion-Charge Load Controller With Meter
40A Amp Wind/Solar Diversion-Charge Load Controller No Enclosure
85 AMP 600V VOLT STUD BLOCKING DIODE WIND/HYDRO/SOLAR
50A, 3 Three Phase Turbine Disconnect Switch with Brake
6X6Combiner
6" x 6" Dual Bus Combiner Box


 



Coleman Air







100 Amp, Dual Bus, Combiner Box


Nema 3R, all metal weather-tight lockable enclosure.



Perfect for paralleling solar panels or multiple wind turbines (after the rectifier, but before the battery). The enclosure can be mounted outdoors with no additional protection from normal rain and snow. One bus is generally used for the positive wires while the other bus is used for negative wires.


Features.
  • Ten position bus on each side that will hold #16 to #4 AWG wire.
  • One Lug on each side which holds up to # 2 AWG wire.
  • Each buss is fully isolated from each other and the enclosure.
  • Includes a non conductive back plate which helps prevent accidental shorting due to stray wire strands.






Enclosure  specifications:

6" X 6" X 4" NEMA 3R Screw Cover Enclosure

Bodies and doors fabricated from 16, 14, or 12 gauge carbon steel and pre-galvanized steel
Drip shield top and smooth seamless sides and front
Knockouts are standard on bottom of 4.00" and 6.00" deep enclosures
A slip-on reversible cover is securely fastened with screws located along bottom edge
No gasketing is required
Hasp for padlocking or meter seal is provided
ANSI-61 gray polyester powder inside and out over phosphatized surfaces over carbon steel
Pre-galvanized finish with phosphatized surface




Brackets with 1/4" holes are on both top and bottom for easy mounting.

Shown with cover flipped to allow for lock.




Cover flipped with lockable slot upwards under top lip.


 

 










More Info.


Support




Official PayPal Seal


We verify orders.

In addition to standard credit card verification procedures which insure the credit card is not stolen, we also verify the computer IP address, phone numbers, etc., to ensure the person placing the order is not doing so for fraudulent purposes. We work with all applicable agencies to prevent and/or report fraudulent or suspicious activity.

Featured videos

Coleman Air Products

Copyright 2010-2017 Coleman Air, Inc. All rights reserved.

Have Questions? -- Please call us at 1-800-577-4169
'